Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
See the difference
Before
After
Before
After
Before
AfterHow Much Does Duct Repair & Sealing Cost in Inwood?
Duct repair and sealing in Inwood typically runs $385 to $1,900, with most single-family homes landing between $550 and $1,200 for a job that combines sealing a few known leaks with reconnecting or patching a damaged run. Small, isolated repairs (one disconnected joint, a single crushed flex run) usually start around $385, while a full duct-system reseal or a major branch replacement can push toward $1,900 or higher. Your written estimate sets the final price, and we give that estimate free.
Here’s what most people don’t realize about duct pricing: the number you get quoted has less to do with the square footage of your home and more to do with how many leaks the technician actually finds and how hard they are to reach. A ranch house with exposed basement ducts is a different animal from a three-story walk-up where the trunk line disappears behind a finished ceiling. We walk the whole system before we quote, because guessing from the doorway is how bad estimates happen.
Duct Repair & Sealing Cost Breakdown (2026)
These are typical 2026 ranges for the Inwood market. Treat them as a planning tool, not a final bill. The written estimate you get after we inspect your system is the price that counts.
| Line Item | Typical Inwood Range |
|---|---|
| Single joint reseal (one disconnected or loose fitting) | $145 – $260 |
| Spot repair on one damaged flex or rigid run | $185 – $385 |
| Partial duct system reseal (5 to 10 leaks) | $385 – $750 |
| Full duct system reseal (whole-house, sealed and tested) | $750 – $1,900 |
| Replace a crushed or collapsed flex run | $250 – $520 per run |
| Patch or replace a section of rigid sheet-metal trunk | $420 – $900 |
| Reconnect a duct that has come off the air handler | $285 – $575 |
| Mastic + mesh sealing at boots, registers and plenums | $65 – $145 per point |
| Seal and insulate ducts in an unconditioned space | $550 – $1,400 |
| Duct repair combined with a full air duct cleaning | $650 – $1,650 combined |
| Repair that requires cutting into a wall or ceiling | Add $300 – $700 for access work |
What pushes a bill toward the top of the range? Number of leaks found, accessibility, and whether the damage is in flex duct (easy) or rigid metal trunk line (slower, more parts). What keeps it near the bottom? A tight, accessible system with a handful of obvious breaches. Most Inwood jobs sit in the middle. When we run a repair, we use mastic and mesh rather than duct tape, because tape fails at temperature and the leak comes right back. That’s a slower repair, and it costs a little more up front, but it’s the one that holds.
One thing worth saying plainly: sealing and cleaning are different jobs that belong together. If we seal a leaky system that’s full of debris, the system just holds contaminated air a little better. If you’re already booking air duct cleaning in Inwood, that’s the moment to have the leaks addressed too, while the equipment and the access are already in place.
What Affects Duct Repair & Sealing Pricing in Inwood
Inwood sits at the northern tip of Manhattan, and the housing stock here shapes duct pricing in ways that a suburban estimate calculator won’t capture. A few factors do most of the work:
- Building type and how the ducts run. Inwood’s housing is a mix of pre-war walk-ups along Broadway and the side streets near Inwood Hill Park, single-family homes and small multifamily buildings on the quieter blocks, and a number of older converted and subdivided layouts. In a pre-war walk-up, ducts are often short runs or plenum-based systems squeezed behind original plaster walls. In a converted house, the ductwork may have been added or extended over several decades, which means uneven sizing and connections that were never properly sealed to begin with. Both types take more inspection time, and inspection time is a real cost.
- Access behind finishes. Wall and ceiling cuts for access are one of the biggest swing factors in an Inwood quote. Plaster and lath is harder to open cleanly than drywall, and in rent-controlled or co-op buildings you may need building sign-off before any cuts happen. Where a run is reachable through a basement, a closet, or a soffit, the repair costs less because the access already exists.
- How many leaks the technician finds. A visible disconnected joint is one price. A system with eight or ten breaches across boots, plenums, and trunk joints is another. We don’t quote blind; we seal and verify as we go, which is how you get a number that matches the job.
- Flex duct versus rigid metal. Flex runs are fast to replace and generally cheaper. Rigid sheet-metal trunk line needs patching, sometimes fabrication of a new section, and time. A lot of older Inwood systems are rigid, which means the per-foot work costs more than a modern suburban flex system.
- Whether the ducts sit in a conditioned or unconditioned space. Ducts running through an attic, a crawlspace, or an exterior chase lose heat or cooling to the outside, and need insulation along with sealing. Sealing plus insulating runs higher than sealing alone.
- Whether repair is paired with cleaning. Combining duct repair and sealing with a full duct cleaning is almost always cheaper than booking them separately, because the equipment and access are already on site and the system only comes apart once.
One local note on timing: New York City’s cold months put heating systems under real load, and that’s when small leaks in a poorly sealed system show up as rooms that won’t warm up or a boiler or furnace working harder than it should. Duct problems get noticed in winter. They get fixed in the shoulder months when scheduling is easier. If you’re hearing odd whistles from a register or noticing dust on the furniture after weeks of no cleaning, that’s a leak telling you it’s there.
If your system needs the full treatment, duct repair & sealing is where we draw the line: we find the breach, seal it, and verify the seal holds before we leave.
How to Save on Duct Repair & Sealing
You don’t need to pay top dollar to get a properly sealed system. A few things make a real difference:
- Get the free estimate, and get it in writing. We’ll walk the system with you so you can see what we’re seeing. No charge, no obligation. Call (855) 974-7305 to book it. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
- Pair repair with a cleaning. If the ducts haven’t been cleaned recently, doing both in one visit saves you the second setup and the second trip. It also means the system is clean before it gets sealed, so you’re not sealing debris in.
- Fix the easy leaks first. Boots, registers, and plenums are the most common leak points and the least expensive to seal. Knock those out and you may find the bigger repair is smaller than you feared.
- Keep records of any HVAC work done. If your furnace, air handler, or ducts were serviced or modified, having that paperwork helps a technician locate non-standard fittings and avoid unnecessary exploratory cuts.
- Seal before you insulate. Insulating a leaky duct doesn’t stop the leak; it hides it. Always seal first, then insulate. Doing it in the other order doubles the cost.
- Watch for a leak that gets worse. A disconnected joint that’s draining conditioned air into the wall cavity for a season can lead to moisture problems that cost more than the original repair. Small fixes stay small when you catch them early.
We work with professional-grade equipment: Rotobrush and Nikro duct cleaning systems, and Abatement Technologies gear for containment and negative pressure. That matters for cost too, because proper containment means less mess to clean up and less collateral damage to the household. It’s the standard NADCA-aligned professionals work to. It’s not a marketing line; it’s why the job takes a bit longer and costs a bit more up front, and why you don’t find yourself calling us back for the same leak in six months.
FAQs – Duct Repair & Sealing Cost
What does duct repair and sealing typically cost in Inwood?
Most Inwood duct repair and sealing jobs run $550 to $1,200, with whole-house reseals reaching $1,900 and single joint repairs starting around $385. The final price depends on leak count, access, and duct type. Call (855) 974-7305 for a free written estimate; the estimate sets the price.
Is it cheaper to repair the ducts or replace the whole system?
Repair is almost always cheaper than replacement when the duct layout is sound and the problem is leaks. A full reseal at $750 to $1,900 is a fraction of duct replacement, which often runs several times higher. Replacement only makes sense when the system is undersized, badly configured, or damaged beyond patching. A free inspection will tell you which side of that line you’re on. Call (855) 974-7305.
Can you come today?
We offer same-day service when scheduling allows, and we answer the phone 24/7. Fast dispatch runs 7am to 7pm, Sunday through Friday. Call (855) 974-7305 and we’ll book you into the earliest opening.
Why does duct sealing cost more in an older Inwood building?
Older Inwood buildings often have rigid metal ductwork, plaster-and-lath walls, and ducts that were extended or modified without proper sealing. Opening plaster is slower and harder to close cleanly than drywall, and extended systems tend to have more joints to find. That access and inspection work is where the extra cost comes from, not the sealing itself. Call (855) 974-7305 for an estimate specific to your building.
How long does duct repair and sealing take, and does that affect the price?
A small repair can take under two hours; a full reseal with cleaning can take most of a day. We bill per job by written estimate, not by the hour, so the time it takes is on us. The price you’re quoted is the price you pay. Call (855) 974-7305 for a free quote.
Do I need to clean the ducts before sealing?
Yes, if the system hasn’t been cleaned recently. Sealing seals in whatever’s already there. Duct repair and sealing pairs best with a full cleaning, and we also handle dryer vent cleaning, HVAC cleaning, and air quality sanitizing with Guardsman-grade treatments, so one call covers the full air pathway. Call (855) 974-7305 to schedule both together.
What Happens When You Call
We walk the system with you, show you what we find, and give you a written estimate before any work begins. No fees, no obligation, and no surprises on the invoice. Our technicians have up to 8 years of experience, and the local professional you work with is licensed and insured as their state requires. When the job is done, we show you the before-and-after so you can see the difference before we leave. Call (855) 974-7305. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Pricing reflects the Inwood market as of 2026. Air Duct Cleaning Inwood offers free estimates – call (855) 974-7305.
Written by the team at Air Duct Cleaning Inwood.
What Our Customers Say
"Ran a negative air machine on the whole system rather than the shop vac on a stick that the cheap outfit down the road uses. Showed me the before and after photos from inside the trunk line and it was genuinely disgusting."
- Nicole Anderson"Did the dryer vent while they were here for a small add on price. The dryer now finishes a load in one cycle instead of two."
- Shannon Barrett"My wife's allergies had been bad in this house since we moved in. It's been two months since they did the ducts and it's noticeably better. Not a miracle, but real."
- Jason Rhodes