Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Trusted Duct Repair & Sealing for Inwood Homeowners
If your energy bills climb while some rooms never quite heat or cool, a breach in the duct system is often the reason. Duct repair and sealing in Inwood is the work of finding those breaches and closing them, so the air you pay to condition reaches the rooms it’s meant for instead of leaking into a wall cavity or a basement. Cleaning alone won’t fix a torn flex run or a joint that was never sealed properly, and it won’t stop the re-contamination that follows. Our technicians have up to 8 years of experience and use professional-grade Rotobrush and Nikro equipment, so the repair is verified rather than guessed at. We can often schedule same-day work in Inwood. Call (855) 974-7305 for a free estimate.
What Our Duct Repair & Sealing Service Includes
Duct repair and sealing covers every link in the air pathway, from the trunk line at the air handler to the last supply boot in a bedroom ceiling. Here’s what each part of the job involves and when it applies to a home in Inwood.
Duct Sealing
Duct sealing closes the gaps at joints, seams, and connections where conditioned air escapes before it reaches a register. It’s the right call when you notice weak airflow at the far end of the system, dusty rooms, or a utility bill that doesn’t match how much you’re actually running the system. We seal with mastic and appropriate tape at accessible connections, then confirm the improvement with airflow checks before we leave.

Flex Duct Repair
Flex duct is the ribbed, insulated run you’ll find in attics, crawlspaces, and above ceilings, and it’s the most common failure point in a residential system. It tears at the collar, kinks at a tight turn, or separates entirely when a run is stretched too far. We repair and re-secure flex runs at the connection points, replace sections that are crushed or torn beyond a simple fix, and make sure the run has a clean path without sharp bends that choke airflow.

Metal Duct Repair
Metal ductwork is durable, but it separates at seams and develops pinhole leaks over time, and the vibration from an air handler works at every joint. A separated trunk section can dump a large share of your conditioned air into a basement or chase. We reseal metal joints, reattach separated sections, and reinforce connections so the trunk holds together under normal system pressure.

Duct Insulation
Duct insulation keeps conditioned air at the temperature it left the unit with. Uninsulated or degraded runs through an unconditioned attic or crawlspace lose heat in winter and gain it in summer before the air ever reaches a room. We replace damaged insulation wrapping and make sure runs through unconditioned space are properly covered, which matters in a building stock as varied as Inwood’s.
Mastic Sealant
Mastic is the brush-on sealant that’s standard for ductwork because it stays flexible and bonds to both metal and flex collars. Standard duct tape dries out, loses adhesion, and peels within a season or two. We use mastic at joints, seams, and boot connections where it belongs, which is the difference between a seal that holds and one that fails quietly.
Air Leak Repair
Air leak repair is the diagnostic side of the job: locating the leaks that matter most in terms of lost airflow and energy. Not every leak is worth chasing, so we prioritize the largest losses first. We trace leaks along the accessible system, close the significant ones, and confirm the result with airflow and pressure checks so you can see the difference before we leave.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Brands We Service for Duct Repair & Sealing
We work with Honeywell and Aprilaire systems regularly, which matters because duct repair doesn’t happen in isolation from the rest of the air system. A Honeywell zoning damper or control that’s out of adjustment can make a sealed duct system behave as though it’s still leaking, so we check the controls and accessories alongside the ductwork. Aprilaire humidifiers and air quality accessories tie into the same supply and return runs, and a leak near that equipment undoes much of what the accessory is meant to accomplish.
Our equipment stack includes Rotobrush, Nikro, and Abatement Technologies systems, the same class of professional tools used for containment and negative-pressure work during repair and cleaning. That equipment lets us work without spreading debris through the home while we’re opening connections. Whether you have Honeywell, Aprilaire, or any other make of equipment tied into your ducts, we can help.
Signs You Need Duct Repair & Sealing Right Now
- Rooms that never get comfortable. If the bedroom at the end of the hall stays cold in winter while the living room is fine, a leak or a crushed run is a likely cause. Sealing and repairing the run usually restores the balance without touching the thermostat.
- Utility bills that don’t match your usage. A duct system leaking into an attic or crawlspace means you’re paying to condition air that never arrives. The loss tends to show up as a bill that climbs while comfort doesn’t improve.
- Visible tears, separated joints, or crushed flex runs. If you’ve been in the attic or basement and seen a disconnected collar, a torn flex jacket, or a run squashed against a joist, that’s a leak. It’s worth fixing before it widens.
- Dust that returns quickly after cleaning. Ducts that pull air from a dirty attic or crawlspace through a breach re-contaminate the home every time the system runs. Sealing the breach is what stops the cycle.
- Musty or stale odors when the system starts. Odor that arrives the moment the blower kicks on often traces back to air drawn through an unsealed opening from a damp space. Repairing the breach and addressing the source is the durable fix.
Our Duct Repair & Sealing Process – Step by Step
- 1
Inspection and air-pathway assessment. We start by looking at the whole system, not just the register you’re worried about. That means checking accessible ductwork, connections at the air handler, and the condition of flex and metal runs throughout the home.
- 2
Leak detection and prioritization. Not every gap needs attention; the ones that matter are the largest losses. We identify where air is escaping and rank the repairs by impact so the work you pay for actually changes how the system performs.
- 3
Repair and reseal. We reattach separated sections, replace torn flex runs where needed, and seal joints and seams with mastic at the connections that count. Abatement Technologies containment and negative-pressure practices keep debris from spreading through the living space while we work.
- 4
Verification with airflow and pressure checks. After sealing, we confirm the change with airflow and pressure readings rather than assuming the job worked. This is where the equipment difference shows: professional instruments give you a number, not an opinion.
- 5
Before-and-after documentation. We show you photos of your own ductwork and walk through what we found and what we changed. You see the difference before we leave, and you keep a record of the work.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Duct Repair & Sealing Cost in Inwood?
Duct repair and sealing in Inwood typically runs from about $250 to $450 for a targeted repair on a single run, and from about $600 to $1,500 for sealing a full accessible system with multiple leaks and connections. Whole-system repair that includes replacing several flex runs and insulating unconditioned sections usually lands between $1,200 and $2,500 depending on how much of the ductwork is reachable. A typical mastic sealing job on an accessible trunk line runs $400 to $900. Flex duct repair on one or two runs usually comes in around $200 to $500, and adding insulation to exposed runs in an attic or crawlspace runs roughly $300 to $800.
What affects the price
Access is the biggest factor. Ductwork in a finished ceiling or a tight chase takes more time to reach than a run in an open basement. The number of leaks and the length of the runs matter too, as does whether a section can be repaired or has to be replaced. The age and type of ductwork plays a role: metal trunk lines and flex branch runs fail differently and cost differently to fix.
How to avoid overpaying
Ask for a written estimate that separates inspection, repair, and sealing line items, so you can see what you’re paying for. Be wary of a quote that prices per vent or per connection without looking at the system first. Our estimates are free, the price is set per job by the written estimate, and we don’t quote a teaser figure that grows once we’re on site.
Duct Repair & Sealing Near Inwood – Our Service Area
We cover Inwood and the surrounding neighborhoods, including University Heights, Kingsbridge, Spuyten Duyvil, Washington Heights, and Riverdale, along with Bedford Park, Fordham, Tremont, Highbridge, Morrisania, and Concourse. Response times depend on your location and the schedule, but we can often arrange same-day visits in Inwood and nearby areas. If you’re comparing providers, our duct repair & sealing page covers what to expect in University Heights, and the duct repair & sealing page covers Kingsbridge.
Serving Inwood, NY – Our Local Coverage Area
We serve Inwood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Duct Repair & Sealing in Inwood
Duct repair and sealing is the process of finding breaches in your ductwork and closing them so conditioned air reaches the rooms it’s meant for. It covers reattaching separated joints, repairing or replacing torn flex runs, resealing metal trunk lines, and insulating runs that pass through unconditioned space. It’s different from duct cleaning, which removes debris but doesn’t fix the leaks that let new debris in. Call (855) 974-7305 for a free estimate.
Most targeted repairs take two to four hours, and full-system sealing typically takes most of a day. The time depends on access and how many leaks we find. We’ll give you a realistic window when we write the estimate, so you can plan around the work. Call (855) 974-7305 to schedule.
Typical costs in Inwood range from about $250 to $450 for a single-run repair and from about $600 to $1,500 for full accessible-system sealing. Whole-system repairs with multiple replacements can run $1,200 to $2,500. These are estimates; the written estimate sets the final price, and our estimates are free. Call (855) 974-7305 for an exact quote.
Yes, we work with Honeywell and Aprilaire systems regularly. That includes zoning controls and air quality accessories tied into the ductwork, where a leak or a misadjusted damper can undo the benefit of the equipment. Whether you have those brands or another make, we can help. Call (855) 974-7305 to talk through your system.
Yes, same-day service is often available in Inwood, and fast dispatch runs from 7am to 7pm, Sunday through Friday. We answer 24/7. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Call (855) 974-7305.
We stand behind our work and will walk you through what’s covered when we write the estimate. Because every job is different, the warranty terms are set out in writing before work starts. If something isn’t right after we leave, call us and we’ll make it right. Call (855) 974-7305 with questions.
Clear access to the air handler and any attic or crawlspace openings, and move anything stored near the furnace or duct runs. If you have pets, a closed door to the work area helps. You don’t need to do anything else; we handle containment and cleanup. Call (855) 974-7305 to schedule.
Schedule Your Duct Repair & Sealing Service in Inwood Today
Leaking ducts cost you in comfort and on every bill. One call covers the full air pathway: air duct cleaning in Inwood, duct repair & sealing, HVAC cleaning, dryer vent cleaning, and air quality sanitizing. We give you a free, no-obligation estimate, one flat price per system agreed before work starts, and before-and-after photos of your own ducts. Call (855) 974-7305. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Air Duct Cleaning Inwood.